EasyManuals Logo

Performance Tool w54171 User Manual

Performance Tool w54171
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
5. Remove suction probe from dipstick tube, remove cap valve from the reservoir, and pour the used transmission
fluid into a suitable container. Dispense the waste fluid in accordance with your local regulations.
6. Refill the radiator with new coolant in accordance with a proper vehicle maintenance guide.
7. When completed rinse the evacuator reservoir, pump, adapter, and tubes with water based solvent or engine
degreaser, and allow them to dry thoroughly.
NOTE: Due to varying fluid capacities, if the capacity exceeds 8 Quarts/7.5 liters, it may be necessary to empty the
fluid reservoir before resuming the extraction process.
EXTRACTING COOLANT FROM A RADIATOR CONT.
1. Properly park the vehicle on level ground and turn the engine off.
2. Clean the exterior of the power steering fluid reservoir, it’s common for dirt to collect on the reservoir. This
prevents dirt from entering the reservoir when the cap is removed.
3. Remove the cap from the power steering fluid reservoir.
4. Insert the main suction tube into the fluid reservoir until it reaches the bottom, and the other end of the hose is
fully inserted tightly into cap-valve.
5. Extract the used power steering fluid by pumping the evacuator handle several times to create a vacuum. Once
the fluid begins to flow into the reservoir, continue to operate the pump until all oil has been drained, or the
reservoir is full. Once the flow begins, gravity may draw the used fluid out if the evacuator is lower than the source
6. Remove suction probe from reservoir, remove cap valve from the reservoir, and pour the used transmission fluid
into a suitable container. Dispense the waste fluid in accordance with your local regulations.
7. Refill the reservoir with new power steering fluid in accordance with a proper vehicle maintenance guide.
8. When completed rinse the evacuator reservoir, pump, adapter, and tubes with water based solvent or engine
degreaser, and allow them to dry thoroughly.
NOTE: Due to varying fluid capacities, if the capacity exceeds 8 Quarts/7.5 liters, it may be necessary to empty the
fluid reservoir before resuming the extraction process.
EXTRACTING COOLANT FROM THE POWER STEERING RESERVOIR

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Performance Tool w54171 and is the answer not in the manual?

Performance Tool w54171 Specifications

General IconGeneral
BrandPerformance Tool
Modelw54171
CategoryPower Tool
LanguageEnglish

Related product manuals