Performance PLTVALEGMOUNT2430

To Next Page

SOLD SEPARATELY PLTCBBDESKBEAM

Main Desk Beam Parts List

Place the VA metal or wood leg on the top mount plate, and use

bolts (part 3) to lightly tighten the VA leg to the top mount plate.

When everything is in position, then screw in the bolts tightly.

INSTRUCTIONS:

ASSEMBLY INSTRUCTIONS

MODEL: PLTVALEGMOUNT2430

1 of 2.

IN THE CARTON:

Leg Part List

3. Slide the metal cross beam slightly through the opening found at the top

of the leg

4. Fasten the second leg to the top following steps 2 and 3

5. Centre the cross beam so that it is placed evenly through the opening of

both legs

6. Tighten the cross beam to each leg by using two of the set screws with

Allen Key

7. Use wood screw (part 2) to attach the leg to the work surface.

STEP 1

STEP 2

STEP 3

STEP 4

1. Place top upside down on a clean surface

2. PLBE/PLT table tops are used for several applications, and have many

metal inserts. Only two of these inserts are used for the PLTVALEG.

These inserts are the “A1” inserts, as per the PLT instructions.

Before assembly, please remove all parts from the carton, verifying that you have the correct quantities, and read all the instructions.

**Please Note: When attaching the metal legs to the laminate tops, not all of the provided holes on these metal legs will line

up with the metal inserts on the laminate tops. The provided wood screws may also need to be used**

Need help?

Do you have a question about the Performance PLTVALEGMOUNT2430 and is the answer not in the manual?

Summary

Assembly Instructions

Step 1: Attaching the VA Metal Leg

Attaches the VA metal leg to the top mount plate using bolts.

Step 2: Tabletop Preparation

Prepares the tabletop by placing it upside down on a clean surface.

Step 3: Cross Beam Installation

Installs the metal cross beam through the leg opening and fastens the second leg.

Step 4: Final Securing

Tightens the cross beam to legs and attaches the leg to the work surface.

Safety Warnings and Precautions

General Assembly Caution

Do not tighten screws until the unit is completely assembled.

Maintenance Check

Ensure all bolts are tightened before use and check every six months.

Product Condition Warning

Stop use if parts are missing, broken, damaged, or worn until repaired.