Why does the workpiece lift up from the sanding disc/table of my Performax Sander?
When using the Performax Sander, sand on the right side of the sanding disc as the operator faces the disc.
Explains the importance and procedure for grounding electrical tools to prevent shock.
Provides guidance on selecting and using extension cords for safe and efficient tool operation.
Instructions for carefully unpacking the sander and its components before assembly.
Steps for correctly installing the sanding disc and its protective guard.
Guide on how to mount and secure the disc sander table in the correct position.
Instructions for attaching and adjusting the work support for sanding operations.
Details on securely mounting the sander to a workbench for stability.
Steps for properly installing and tensioning the sanding belt.
How to adjust the sanding belt tracking knob to ensure proper alignment.
Instructions for switching the sanding belt bed between horizontal and vertical positions.
Information on connecting and using the dust port for dust collection.
Steps for removing the old sanding disc and installing a new one.
How to ensure the work tables are square to the sanding surface for accurate sanding.
Steps to ensure the work support is square to the sanding belt for proper operation.
Details on the keyed switch for starting, stopping, and securing the sander.
Technique for holding and moving the workpiece on the sanding belt.
Method for sanding inside curves using the idler drum end.
How to sand workpiece ends and outside curves using the disc.
Instructions for changing the belt station between horizontal and vertical positions.
How to use the miter gauge for disc sanding on the table.
Recommended technique for sanding small surfaces with the miter gauge.
Guidance on lubricating moving parts for smooth operation.
Steps for adjusting the tension and alignment of the drive belt.
To Next Page
General
