5
stripes is the equipment-grounding conductor. If repair or replacement of the
electric cord or plug is necessary, do not connect the equipment-grounding
conductor to a live terminal. Repair or replace a damaged or worn cord
immediately. Stay constantly aware of cord location and keep it well away
from the rotating grinding wheels.
DIRECTION OF FEED. Feed work into a blade or cutter against the direction
of rotation of the blade or cutter only.
NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. Don’t leave
tool until it comes to a complete stop.
INSPECT EXTENSION CORDS PERIODICALLY AND REPLACE IF DAMAGED.
DO NOT USE TOOL IF SWITCH DOES NOT TURN IT ON AND OFF. Have
defective switches replaced by an authorized service center.
USE ONLY CORRECT WHEELS. Do not use wheels with incorrect size holes.
Never use wheel washers or wheel bolts that are defective or incorrect. The
maximum wheel capacity of your grinder is 8in.
NEVER TOUCH WHEEL OR OTHER MOVING PARTS DURING USE.
DO NOT OPERATE A TOOL WHILE UNDER THE INFLUENCE OF DRUGS,
ALCOHOL, OR ANY MEDICATION.
WHEN SERVICING, use only identical replacement parts. Use of any other
parts may create a hazard or cause product damage.
USE ONLY RECOMMENDED ACCESSORIES, listed in this manual or
addendums. Use of accessories that are not listed may cause the risk of
personal injury. Instructions for safe use of accessories are included with the
accessory.
DOUBLE CHECK ALL SETUPS. Make sure wheel is tight and not making
contact with workpiece before connecting to power supply.
SPECIFIC SAFETY RULES FOR BENCH GRINDER
NEVER REACH TO PICK UP A WORKPIECE,
a piece of scrap, or anything else
that is in or near the grinding path of the wheel.
AVOID AWKWARD OPERATIONS AND HAND POSITIONS,
where a sudden
slip could cause your hand to move into the wheel. Always make sure you
have good balance.
To Next Page
Loading...
General