1 | P a g e
Support Line: 0714 224 098/ 020 232 4766
Prepared by: Pergamon limited
TIMS SIMPLIFIED MANUAL (INCOTEX 181)
1. POWERING ON
a. Hold Button for 7 seconds (You see on ready/ You
hear a BEEP SOUND)
b. Release your hand (machine starts initializing process and goes to
MODE 1 ------ after 7 seconds)
2. POWERING OFF
a. Hold VD/MODE for 5 seconds till you see OFF RDY
b. Release your hand. (Machine shall turn OFF immediately)
MODE OF OPERATIONS
1. MODE 1: REGISTRATION MODE
2. MODE 2: X REPORT MODE
3. MODE 3: Z REPORT MODE
4. MODE 4: PROGRAMMING MODE
5. MODE 5: SERVICE MODE
NAVIGATING THROUGH THE MODES
• To get to the next mode press key.
TO NAVIGATE IN AND OUT OF THE MODES
a) Get in the mode
• press the button once.
b) get out of the mode
+ • Press
LOADING THERMAL ROLL
identify the thermal side of the roll by scratching the paper, Thermal
side writes and load the thermal paper while facing the printer head.
As illustrated bellow.
1. open the roller cover
2. Place thermal roll
3. Close roller cover
To Next Page
Need help?
General
