0166ES | 03/2019 | 5 of 6MOHAWK TECHNICAL SERVICES DEPARTMENT | 508 EAST MORRIS STREET, DALTON, GA. 30721 | 888.387.9881
Pergo Extreme Installation Instructions
Finishing (cont.)
2. When the new flooring meets a threshold or a doorway, we recommend undercutting the door
jamb. To secure the right cut, turn a plank upside down and place it on the floor up to the door
frame. Then place a handsaw flat against the plank and simply cut through the frame. Remove
the cut-out piece and vacuum away debris. You can now secure the plank on the long side at
the side of the door jamb. Use an installation tool pull bar to securely join the long and
short joints.
3. If it is dicult to tilt the planks (e.g. under radiators), use a pull bar installation tool to pull the
planks together.
4. In rows where there is a pipe, make sure the pipe falls exactly in line with the short side of two
planks. Select a drill bit with the same diameter as the pipe plus 1/2 inch (13 mm). Click the
planks together on the short side and drill a hole centered on the joint between the two planks.
Then install the planks.
5. For a double pipe, drill a hole equivalent to the diameter of the pipe plus 1/2 inch (13 mm) at
each of the marked points. If located on the long side of the plank, make a 45° cut from each
hole to the edge of the plank.
Then, using an appropriate glue along the cut edges of the piece you cut out,
glue the piece in place. Be sure no glue comes between the cut-out piece and the
subfloor.
Maintenance
For full care and maintenance instructions for residential and commercial
applications, please visit www.mohawkflooring.com.
1. Use a vacuum cleaner suitable for hard surface flooring (with no moving parts
and without rotary beater bars) to clean your Pergo Extreme floor. Your Pergo
Extreme floor can also be cleaned with a damp or wet mop.
Never use a steam cleaner on your Pergo Extreme floor.
2. Remove spills from the floor immediately.
Pergo Extreme
www.Pergo.com
To Next Page
Loading...