6. Operate the hand primer. When fuel free from air
flows from the connector tighten the connector
bolt.
7. Try to start the engine.
Note: Do not operate the starting motor for more than
15 seconds. If the engine does not start after 15
seconds, stop and wait for 30 seconds before trying
again.
i02154450
Fuel System Filter - Replace
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
NOTICE
Do not allow dirt to enter the fuel system. Thoroughly
clean the area around a fuel system component that
will be disconnected. Fit a suitable cover over discon-
nected fuel system component.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
Fuel Filter With Canister
1. Close the fuel supply valve.
Illustration 53 g01122129
2. Clean the outside of the fuel filter assembly.
3. Open the fuel drain (2) in the bottom of the filter
assembly, if equipped. Drain the fuel into a
suitable container.
4. Loosen the setscrew (1).
5. Remove the canister (3).
74
SEBU7992-05
Maintenance Section
Fuel System Filter - Replace
To Next Page
Loading...
