4
II. INSTALLATION AND OPERATING INSTRUCTIONS
1. CHECKS BEFORE INSTALLATION
* Visually inspect the exterior of the shipping container, and any severe damage noted
should be reported to the carrier.
WARNING
Remove shipping tape(s) and packing as follows. If any are left in the Ice Maker,
it will not work properly.
IMPORTANT
1. Remove shipping tape holding the Door.
2. Ensure all components, fasteners and thumbscrews are securely in place.
* Remove the package containing accessories. Remove shipping tape holding the Separator
.
to the Ice Making Mechanism.
* Check that refrigerant lines do not rub or touch lines or other surfaces.
* Check that the compressor is snug on all mounting pads.
* Make sure that the voltage supplied to the Ice Maker is 115-120 Volts, 60hz, single
phase AC.
To Next Page
Loading...
