NOTE: EXTENSION OF LEG LEVELERS
WILL INCREASE ASSEMBLY HEIGHT
68
7
8
"
95010 REV C
sheet metal screws (where the rivets were drilled out in step 1).
in step 2) by using 1/4-20 machine screws . Flange should be
STACKING KIT INSTALLATION
pointing away from the bottom of the unit.
Step 3: Attach mounting plate (where the leg levelers were removed
Step 4: Place upper unit on top of lower unit and attach using #10
-3-
8300 W. Good Hope Rd. Milwaukee, WI 53223 Phone: (414)353-7060 Fax: (414)-353-7069 perlick.com
Perlick is comitted to continuous improvement. Therefore, we reserve the right to change specifications without warning
Flange
Bottom of
cabinet
To Next Page
Need help?
General
