How to fix Permobil M400 Corpus HD Wheelchair that does not start?
If your Permobil Wheelchair isn't starting, there are a few potential causes. First, the batteries might be discharged, so try charging them. Another possibility is that the cable connection to the control panel has come loose; in this case, insert the cable back into the control panel.
Why does my Permobil M400 Corpus HD turn off by itself?
If your Permobil Wheelchair turns off after a period of inactivity, it's likely because the energy-saving mode has been activated. Simply switch the wheelchair back on using the start button on the control panel.
What to do if my Permobil Wheelchair cannot be driven?
If your Permobil Wheelchair won't drive, check if the battery charger is connected and stop charging, disconnecting the charging cable from the wheelchair. Also, verify that the brake release is not activated; if it is, reset the brake release. Finally, ensure the wheelchair is unlocked.
How to contact Permobil for technical assistance and required information.
Explains the meaning of DANGER, WARNING, CAUTION, NOTICE, and information symbols used in the manual.
Illustrates the electrical connections for the seat components.
Information on interpreting diagnostic screens, error messages, and codes displayed on the R-net LCD panel.
Explains battery indicators and troubleshooting based on LED patterns.
General| Drive Type | Rear-Wheel Drive |
|---|---|
| Frame Material | Aluminum |
| Weight Capacity | 450 lbs |
| Seat Depth | 16" - 20" |
| Maximum Speed | 6 mph |
| Battery Charger | 8 amp, off-board |
| Overall Width | 26" |
| Battery Type | Group 24 |
To Next Page