© 2010 - 2020 Persistent Systems, LLC – All Rights Reserved
The export and/or the release of certain products, technology and software to non-US persons might
be subject to export restrictions. Please refer to the US export laws & regulations for details.
PAGE 19 OF 176
PHYSICAL SETUP: RF SETUP
?
How do I tell if my antennas and RF modules are compatible?
Find the part numbers on the antennas. Antenna part numbers are on a sticker wrapped around the base
of the antenna.
1
Find the part number on the RF module. The RF module part number is on a sticker on the back of the RF
module.
2
Each part number will begin with ANT- (antennas) or RF- (RF modules) followed by four (4) digits. The first
digit references the RF band of the part. Make sure that the first digit of the antennas and RF module
match.
3
!
WARNING!: DO NOT use mismatched antennas and RF modules. This configuration will result in very poor
performance and/or damage to the device. If you do not have matching antennas and RF modules, contact
Persistent Systems.
!
WARNING!: DO NOT switch RF modules while device is powered on. Power off device before changing RF
modules.
!
WARNING!: the MPU5 is not IP68 rated when the RF module is not attached. Ensure you are in a dry, dust-
free environment before changing RF modules.
!
WARNING!: User MUST refer to the Professional Installer – Compliance Section of this manual for ap-
proved antenna types. This warning applies only to RF-2100 with the FCC ID 2AG3J-RF2100, RF-5100 with the
FCC ID 2AG3J-RF5100, and RF-2150 with the FCC ID 2AG3J-RF2150.
To Next Page
Loading...