© 2010 - 2020 Persistent Systems, LLC – All Rights Reserved
PAGE 28 OF 176
The export and/or the release of certain products, technology and software to non-US persons might
be subject to export restrictions. Please refer to the US export laws & regulations for details.
PHYSICAL SETUP: POWER
1
If you are using a battery, make
sure that the battery is charged.
2
Align the circular three pin connector on
the power source with the circular three
pin connector on the bottom of the MPU5.
3
Push the connectors together. Make sure
the connector is seated properly.
Connecting Power
To Next Page
Loading...