EasyManuals Logo
Home>Persistent Systems>Radio>Wave Relay MPU5

Persistent Systems Wave Relay MPU5 Basic Operator Manual

Persistent Systems Wave Relay MPU5
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
© 2010 - 2020 Persistent Systems, LLC – All Rights Reserved
NO NDA REQUIRED
The export and/or the release of certain products, technology and software to non-US persons might
be subject to export restrictions. Please refer to the US export laws & regulations for details.
03EN073 Rev. M
PAGE 41 OF 176
SOFTWARE SETUP: MANAGEMENT COMPUTER
!
IMPORTANT INFORMATION!:
To communicate with an MPU5, the computer must have an IP address in the same subnet
mask as the MPU5’s IP address.
For example, with a subnet mask of 255.255.255.0, the computer and MPU5 will be able
to communicate if they share the same first three numbers in their respective IP addresses
(e.g. 10.3.1.10 and 10.3.1.254).
If the computer and MPU5 do not share a subnet mask, the computer and MPU5 will not
be able to communicate.
If either the computer or MPU5 do not have an IP address in the same subnet mask, the
computer and MPU5 device will not be able to communicate.

Other manuals for Persistent Systems Wave Relay MPU5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Persistent Systems Wave Relay MPU5 and is the answer not in the manual?

Persistent Systems Wave Relay MPU5 Specifications

General IconGeneral
BrandPersistent Systems
ModelWave Relay MPU5
CategoryRadio
LanguageEnglish