024-53730
1
INSTALLATION INSTRUCTIONS
P/N 53730 & 53735
(EZ Fit Starter for 1965-1988 Big Twin Harley Davidson’s®)
Parts List:
(1) Compu-Fire Starter
(2) 1/4-20 X 3/4” Socket Head Cap Screw
(2) 10-24 X 3/4” Socket Head Cap Screw
READ THESE INSTRUCTIONS COMPLETELY BEFORE BEGINNING
INSTALLATION!
NOTE: Refer to the Factory Shop Manual electrical section for safety instructions prior to
preforming any repairs or installations of electrical components.
CAUTION! ALWAYS DISCONNECT THE BATTERY CABLES BEFORE PERFORMING ANY
ELECTRICAL SYSTEM REPAIRS OR MODIFICATIONS.THIS WILL PREVENT DAMAGE TO
THE ELECTRICAL SYSTEM OR ACCIDENTAL STARTING OF THE MOTORCYCLE IN CASE
OF AN ELECTRICAL ARC CAUSED BY SHORTING THE BATTERY POWER TO GROUND.
WARNING! SEVERE DAMAGE TO THE ELECTRICAL SYSTEM OR PERSONAL INJURY
MAY OCCUR BY NOT FOLLOWING THE ABOVE SAFETY INSTRUCTIONS.
Step #1 STARTER REMOVAL:
1. Disconnect the Battery Cables from the battery, always disconnect the negative
cable first.
2. Remove the Nut that connects the battery cable to the starter and remove the
cable.
3. Loosen the two long bolts that mount the starter to the starter gearbox housing and
then remove the starter from the motorcycle.
To Next Page
Need help?
General