PerTronix T3001 - User Manual

Contents:
1 - 9” Quick Change Ratchet Crimp Tool
1 - (A) Insulated Crimp Die
1 - (B) Non-Insulated Crimp Die
1 - (C) Open Barrel Crimp Die
1 - (H) Open Barrel D-Sub Die
1 - (H1) Spark Plug Wire Die
Using the tool
Place the terminal to be crimped so that the wire
receiving end points to the left and the terminal
end points to the right. Slowly squeeze the tool
handles so that the terminal is held in place with-
out crimping the terminal. The Crimp portion of
the terminal should be flush with the right side of
the crimp die. Insert the bare wire into the terminal
and squeeze the tool handles until the tool returns
to the open position. If for any reason the ratchet
mechanism needs to be released mid cycle, press
the release lever, located between the handles, forward.
PerTronix Quick Change Ratchet Crimp Kit
Release Lever

Summary

Using the tool

Die Changes

(A) Insulated Crimp Die

Details the insulated crimp die for the ratchet crimp tool.

(B) Non-Insulated Crimp Die

Details the non-insulated crimp die for the ratchet crimp tool.

(C) Open Barrel Crimp Die

Details the open barrel crimp die for the ratchet crimp tool.

(H) Open Barrel D-Sub Die

Details the open barrel D-Sub crimp die for the ratchet crimp tool.

(H1) Spark Plug Wire Die

Details the spark plug wire crimp die for the ratchet crimp tool.

Adjustment

PerTronix T3001 Specifications

General

Brand	PerTronix
Model	T3001
Category	Crimp tool
Language	English