TB 100
PAG. 23 Cod. 29050055 Rev.01 Edit: 09/2015
6.14 Fault finding
Engine will not start STOP button Pull out to release
Engine stop switch Push to I - start position
Fuel Fill tank - check tap on
Oil pressure Check oil level
Drive guard Fit to engage cut-out switch
Engine not at correct speed
Engine throttle Check operation
Cutter not rotating Blockage Clear
Drive belt tension Re-tension or replace
Discharge does not flow Discharge chute Check for blockage
Cutter unit Check for blockage
Unusual noise(s) Bearings Check and replace
7.1 Long-term storage
7.1.1 Clean the machine thoroughly and list any required spares for ordering.
7.1.2 Carry out any required maintenance on the machine, as referred to in the
After 250 h maintenance section, unless completed.
7.1.3 Fit in any spares, as required.
7.1.4 Drain the fuel (in the engine driven version only)
7.1.5 If the machine is to be kept in storage over 3 months, it must be put on the wooden
blocks to take the weight off the wheels.
7.2 Start-up after long-term storage
7.2.1 Check the pressure in the tyres (see Section 6.9)
7.2.2 Get the machine ready for work (see Section 4)
If the machine is to be scrapped at the end of its working lifetime, the following
components must be processed exclusively in the authorised utilisation centres.
Engine/gearbox oil - tyres - rubber parts.
If in doubt, please consult with a regional authority in charge of environmental matters.
To Next Page
Loading...
General