What to do if Pet Stop Pet Fence System receiver is not detecting the signal?
First, ensure that the transmitter is powered on and emitting a radio signal. Next, verify that the receiver battery has been recently replaced and correctly installed. If the problem persists after these steps, it's recommended to contact your local Pet Stop dealer.
Why is my Pet Stop Pet Fence System transmitter beeping and the display flashing?
Ensure each boundary wire is correctly connected to the terminal connections on the transmitter. Also, check the boundary wire in the yard for any damage. You can quickly test this by placing a jumper wire across the loop connections on the transmitter. If the transmitter functions normally with the jumper wire, there's a break in the boundary wire. Visually inspect for the break or contact your Pet Stop dealer for assistance.
What to do if my pet is not responding to the correction from Pet Stop Pet Fence System Pet Care Product?
Check the fit and snugness of your pet’s receiver collar, ensuring the soft probes make good contact with your dog’s skin. Verify that the receiver battery was recently replaced and properly inserted. If your receiver uses Comfort Contacts[®] with rubber tips, make sure they are replaced, potentially as often as every six months, depending on your pet.
How to fix Pet Stop Pet Fence System Pet Care Product transmitter with no digital display reading?
First, ensure the transmitter is turned on by pressing the UP button once or twice. Check the AC electrical outlet to confirm it's plugged in and providing power. Plug in another device, like a hair dryer or radio, to ensure the outlet is functioning correctly. Also, if the transmitter is plugged into a GFI outlet, ensure it's reset and working.
What to do if the low battery indicator is flashing on my Pet Stop Pet Care Product receiver?
When the low battery indicator is flashing, it indicates that the battery needs to be replaced. Please refer to the battery replacement section on Page 8 for specific instructions.
Details the transmitter's surge protection and audio-visual alert for lightning strikes.
Explains the transmitter's sensor that alerts to a broken boundary wire.
Describes how to adjust the transmitter's signal field width using UP/DOWN buttons.
Solutions for common transmitter issues like no display or beeping alerts.
Guides to resolve issues with the receiver not detecting signals or pet non-response.
General| Brand | Pet Stop |
|---|---|
| Model | Pet Fence System |
| Category | Pet Care Product |
| Language | English |
To Next Page
