4 Customer Care Center +1 (800) 732-2677
In the Box
Bark Collar
PetSafe
®
RFA-18-11
6 Volt Alkaline Battery
Test Light
Tool
Long Contact
Points
How it Works
The PetSafe
®
Bark Collar has 15 levels of static correction. It begins with low-level corrections. If excessive
barking continues, the correction intensity will increase with each successive bark until the barking stops.
Once the dog has learned to reduce the barking, the initial warning corrections are reduced. As a built-in
safety feature, if your dog barks 15 times or more within a 1 minute 20 second period, the bark collar will
automatically shut off for 3 minutes.
Insert and Remove the Battery
1. Turn the battery door counter-clockwise using the test light tool or a
coin (1A).
2. Insert the 6-volt alkaline battery, negative (–) end first (1B).
3. Replace the battery door turning clockwise (1C).
4. This Bark Collar utilizes a replaceable PetSafe
®
RFA-18 6 Volt Alkaline
battery. A replacement battery can be found at many retailers. Contact
the Customer Care Center or visit our website at www.petsafe.com.
Battery Life
Average battery life is 3 to 6 months, depending on how often your dog
barks. However, due to greater use during your dog’s training, your first
battery may not last as long as replacement batteries. Be sure to discard
the used battery properly.
Two-Color LED
The two-color LED indicator shows good or low battery. Good battery
is indicated by 1 flash every 5 seconds with green LED. Low battery is
indicated by 3 flashes every 5 seconds with the red LED. If there are no
LED lights it is time to change the battery.
To Turn the Collar On
Press and hold the power button until you hear a low to high beep and
the green LED appears, and then release. The green LED will flash once
every 5 seconds.
1A
1B
1C
To Next Page
Loading...
