Basic Operation - Guide
FUNCTION BUTTON
ACTIVATION
LED
INDICATOR
ACTION
Manual Mode Press & Release Red - Solid for 5
seconds
Latch will unlock. Use 4-Way
Lock options for pet access.
Automatic
Mode
Press & Release Green - Solid for
5 seconds
Latch will lock and will only
be activated by reading a
“programmed” microchip ID.
Learn Mode Press & Hold for
5 Seconds until
LED is activated
Red – Solid
for up to 60
seconds
Cat flap will exit Learn
Mode once microchip ID is
programmed. Latch will unlock
after successful programming.
Repeat for additional cats.
Motion Sensor N/A Green - Solid
for the length of
activation
Motion is detected outside
and the cat flap is looking for a
microchip to read.
Low Battery N/A Red - Flashes
every 10
seconds
Replace batteries soon.
Batteries
Replaced
N/A Green – 3 quick
flashes
Cat flap will enter Automatic
mode.
Factory Reset Press & Hold 15
Seconds until LED
is activated
Red - 5 quick
flashes
Cat flap will enter back into
Automatic Mode and be
locked. All programmed
microchip IDs will be erased
from the memory.
Error N/A Red –
Continuous
quick flashing
Remove batteries, wait 30
seconds then replace batteries.
If Red light continues, contact the
Customer Care Centre. Latch
will attempt to unlock for cat flap
to be used in Manual Mode.
4-Way Manual Lock
The 4-Way Manual lock allows you to control your cat’s access in and out of
your home in either direction. Until your pet is thoroughly familiar with using the
cat flap, it is a good idea to anly use the 4-Way Manual lock in the In or Out
position only (Fig. H).
Fully lockedIn or Out Out onlyIn only
Fig. H
Additional Information
For extended information on your PetSafe
™
Microchip Cat Flap including glass
and wall installation, helpful training tips, and available accessories, please
visit www.petsafe.com to download the full product Installation Guide.
Important recycling advice
Please respect the Waste Electrical and Electrical Equipment regulations in
your country. This equipment must be recycled. If you no longer require this
equipment, do not place it in the normal municipal waste system. Please return
it to where it was purchased in order that it can be placed in our recycling
system. If this is not possible, please contact PetSafe
™
Customer Care Centre
for further information.
To Next Page
Loading...
