TESTING PETSPY DOG TRAINING SYSTEM
Shock Test:
•Take the included Test Light and put its metal wire on the
Receiver’s Contact Points.
•Press the Shock Button on the Remote Transmitter.
•e Test Light will light up indicating that shock is working.
•e higher the shock level is the brighter it should be.
Vibration Test:
•Press the Vibration Button on the Remote Transmitter.
•e Receiver Collar will vibrate indicating that vibration stimulation is working.
•Try to adjust the level of vibration and see how the intensity is changing.
Receiver Tone Test:
•Press the Receiver Tone Button on the Remote Transmitter.
•e Receiver Collar will beep indicating that receiver tone is working.
FITTING THE COLLAR
To ensure eective training and dog’s safety, you must properly t the collar on your
dog. e collar must t snugly to allow the “contact points” to have direct contact with
the skin. Position the receiver unit high up on your dog’s neck just below ears.
You should be able to t two ngers between the collar strap and your dog’s skin. Too
tight poses the risk of skin irritation and discomfort. Too loose and the contact points
will not be able to administer the stimulation reliably and can cause skin irritation due
to chang. Cover the contact points with conductive rubber caps to reduce the risk of
skin irritation or injury.
CAUTION: E-collars are not designed to be worn constantly. We recommend using
e-collars only under adult supervision and for no longer than 4 hours per day. NEVER
attach a leash to an e-collar. Use a separate regular collar if there is a need for a leash.
Please refer to PetSpy Dog Training E-Book for more dog training tips.
You can download it at
www.petspystore.com
- it is free!
To Next Page
Loading...
