22
IMPORTANT INSTRUCTIONS
Status LED display
• Permanently red LED – no connection to internet possible
• LED blinking red – ready to connect to Wi-Fi
• LED blinking red quickly – Wi-Fi connection is in progress.
• Permanently blue LED – connection to Wi-Fi works properly
• LED blinking blue – ready for manual connection to Wi-Fi
• LED blinking blue quickly – manual Wi-Fi connection is
established.
• No LED – The camera is turned off / not operational.
Micro-USB cable feeder
The connector supplies power to the camera. If required, conventional
micro-USB cables with different lengths may be used.
Microphone/speaker
The combination of built-in microphone and speaker allows two-way
communication.
Micro-SD card slot
Micro-SD cards up to 128GB in size may be used.
Reset button
The reset button must be pressed with a narrow object for approx. 5
seconds to allow the camera to be reset to factory default settings.
To activate manual Wi-Fi setup, the reset button has to be pressed by
a narrow object for about 1 second.
To Next Page
Loading...