18/20 Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
TYRES
Tyre pressure
Tyre wear
If the wear limit on the tread is reached (B), you are
advised to go to a registered dealer to change the tyres.
BRAKE INSPECTION
Front brake pad wear.
If one of the 2 brake pads is worn down to the minimum
dimensions (A), the 2 brake pads must be changed.
Rear brake lining wear.
Actuate the brake control lever and check the position of
the wear mark on the cam tierod (C) compared to the
mark (D) on the engine housing.
If the cam tierod mark is lined up with or passes the wear
mark on the engine housing, the brake lining must be
replaced.
Brake fluid
If the level is close to the minimum mark, we advise you
to go to a registered dealer to have the braking system
checked and topped up if necessary.
The tyre pressure must be checked once
a month when cold.
Incorrect pressure causes abnormal
wear and affects road behaviour, thus
making driving dangerous.
Tyre pressures
Front Rear
Tyres
10’’
Solo 1.3 bars 1.6 bars
Pillion 1.3 bars 1.8 bars
Tyres
12’’
Solo 1.6 bars 1.8 bars
Pillion 1.6 bars 2 bars
B
When replacing tyres, you are advised to
mount tyres of the same brand and
equivalent quality. In case of puncture, it
is forbidden to mount an inner tube in a
tubeless tyre.
Tyres contain substances that are
harmful to the environment. Your dealer
is equipped to dispose of used tyres
without endangering the environment in
compliance with current standards.
We advise you to visit a registered dealer
for the replacement of these
components.
The level of brake fluid must be checked
regularly via the braking unit inspection
window (A).
Brake fluid DOT 4
D
C
To Next Page
Loading...
Need help?
General
