11 - 40
Adjustment
Fig. 11 - 36
4
2
1
3
+
-
11.06.08 Tansmission linkage (only on the PFAFF 1526)
Requirement
With the thread trimmer in its resting position, transmission cranks 3 and 4 must stand
parallel with each other.
● Set the thread trimmer at its resting position.
● Adjust transmission linkage 1 (screws 2) according to Requirement.
If problems occur in thread catching on the left sewing hook, the catcher stroke
can be increased (+) or decreased (-) by turning transmission crank 3.
To Next Page
Loading...
Need help?
General
