PFAFF 23
Programming - input
With regard to the operation of the machine a distinction is made between sewing and input.
Input is divided into functions for direct selection and functions selected from the menu.
Functions for direct selection
Functions for direct selection can be selected with the keys illustrated below.
- Thread trim ON/OFF
- Increase roller presser feed motion by steps of 0.1 mm if program number 0 is selected.
- Increase roller presser feed motion by steps of 0.1 mm for all segments of a program if
program number 1 to 24 is selected and control is at program start.
- Increase roller presser feed motion by steps of 0.1 mm for individual segments of a program
(only via key on machine head).
- Decrease roller presser feed motion by steps of 0.1 mm if program number 0 is selected.
- Decrease roller presser feed motion by steps of 0.1 mm for all segments of a program if
program number 1 to 24 is selected and control is at program start.
- Decrease roller presser feed motion by steps of 0.1 mm for individual segments of a program
(only via key on machine head).
Functions selected with the menu
(also see menu functions - overview page 19)
Other functions can be selected with menus. To recall the menu, select input mode.
Press - INPUTS appears in the display.
By operating keys (to browse forwards) or (to browse backwards) you move on the main
functions level. By means of the numeric keys the main functions can also be selected directly.
Press to verify a selected function and to start the input or to select a sub-function.
If is pressed you return to the previous function. If is pressed you return to the default state
of the input.
To Next Page
Loading...
