Pfaff 3834-3/11 - Page 28

28 PFAFF
SEGMENT R3 2.9 2.5
This sequence can be continued freely until seam
segment R 15 is reached.
If a sleeve has, say, only 5 seam segments, the
seam end must be programmed after display
SEAM CONTINUATION.
Press or until
END OF SEAM _._ _._
The control is set to the first seam segment of the
left hand sleeve and this can now be programmed.
Display:
SEGMENT L1 _._ 2.5
FEED ROLL. PR. _._ 2.5
and
FEED ROLL. PR. 2.9 2.5
or until:
CONTINUE SEAM 2.9 2.5
SEGMENT L2 2.9 2.5
FEED ROLL. PR. 2.9 2.5
and
FEED ROLL. PR 2.7 2.5
or until:
CONTINUE SEAM 2.7 2.5
SEGMENT L3 2.7 2.5
This sequence can be continued freely until seam
segment R 15 is reached.
If a sleeve has, say, only 5 seam segments, the end
of the program must be programmed after display
SEAM CONTINUATION.
Press or until
END OF PROGRAM _._ _._
PROGRAMMING 2.7 2.5
Old status line appears, say:
9 R1 0 _._ _._
Recall program number 3
PROGRAM NO. 9 _._ _._
PROGRAM NO. 3 _._ _._
3 R1 0 2.7 2.5
Machine is operational, seam start of right hand
sleeve.