Pfaff 3834-3/11 - Changing Roller Presser Feed Motion Segment; Reworking Sewing Segments

36 PFAFF
Changing the roller presser feed motion
within a certain seam segment
Example:
Changing the roller presser feed motion of 2.7 mm
to 3.2 mm in seam segment R3.
INPUT _._ 2.5
PROGRAM NO. _ _ _._ 2.5
Select desired program number with numeric keys
and press enter key.
If desired program number is already displayed,
just press enter key.
SIZE _ _ _._ 2.5
until
SEGMENT R1 _._ _._
SEGMENT R3 _._ _._
FEED ROLL. PR. 2.7 _._
and
FEED ROLL. PR. 3.2 _._
The old status line appears, say:
4 R1 0 50 _._ _._
Reworking beginning with a certain
sewing segment
In case of a sewing disturbance whilst sewing a
certain seam segment (e.g. thread breakage) seam
segments can be reworked as follows:
Pedal in restin position (position 0)
Press - LED on
- the sewing program is interrupted
- the control is set at the beginning of the current
seam segment
Note:
If necessary you can cycle backwards or forwards
by several seam segments - the current seam
segment is always displayed in the status line.
to cycle forwards
to cycle backwards
Actuate pedal to the second position backwards
- sewing threads are trimmed
- needle in high position, roller presser is lifted.
Position the workpiece so that the beginning of the
current seam segment is directly beneath the
needle.
Press -LED off
- the current sewing program is enabled again
- the sewing procedure can be continued.