2:10
Preparations
Attaching the presser foot
Place the presser foot under the presser foot holder (13), so that
when the presser foot lifter (20) is lowered, the pins of the foot
engage in the presser foot holder.
Check:
Please check that the presser foot is properly attached by raising the
presser foot lifter.
Setting the needle thread tension
Set the required amount of the needle thread tension (18) using
the markings on the tension dial.
The normal setting for sewing is 4 - 5. For decorative sewing,
darning and buttonhole sewing 3.
Winding a bobbin through the needle
It is possible to wind bobbins even when the machine is fully
threaded. Raise the presser foot lifter (20) to the top position.
Pull the needle thread underneath the presser foot and upward
through the right-hand threader slot (17).
To Next Page
Loading...
