ENGLISH
ENGLISH
2
4
3
7
6
Thank you for purchasing this Pster product. All Pster products are carefully
engineered, and factory tested to provide long trouble-free use under normal
conditions. This product is easy to install using basic tools and our easy to
follow illustrated instructions.
3 TOOLS RECOMMENDED
• FTFE Plumber’s Tape • Spatula • Safety Goggles
• Sealant • Slotted screwdriver • Phillips Screwdriver
• Pliers • Adjustable wrench • Flashlight
• Cloth
Your installation may require other additional tools.
4 CONTENTS OF THE BOX
A Seat Cover B Wax Ring C Toilet Bowl
D Toilet Tank E Toilet Lid F Installation Kit:
{Rubber Gasket, [Tee Bolts (2), Nuts (2), Washers (2), Plastic Washer (2), Decorative
Cap (2)], [Brass Bolts (2), Wing Nuts (2) Washers (4)]}
G Installation Kit: {Cap (2), Screw (2), Washer (2), Nut (2),Spacer (2)}
5 WORK AREA INSPECTION
Verify that the Waste Outlet Hole is 12” (305 mm) (5A) from the nished wall (5B).
1 BEFORE PROCEEDING
WARNING: This product comes complete for installation. Read all the
instructions completely before proceeding. Pster recommends calling a professional
if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes. This product is heavy and fragile; use extreme care
with all parts!
2 SHUT OFF WATER SUPPLY
Locate main water supply inlets and shut off the water supply valves. These are usually
found near the water meter. If you are replacing an existing toilet, remove the old toilet
and wax ring from the oor and clean the oor surface thoroughly.
6 WASTE OUTLET HOLE PREPARATION
Place and align Tee Bolts (6A) into Flange Groves (6B) located on the Floor Flange
(6C) of Waste Outlet Hole as shown.
7 WAX SEAL INSTALLATION
Carefully turn Toilet’s Base (7A) on it’s side on top of a Secure Padded Surface (7B).
Place Wax Seal (7C) rmly into the outlet of the toilet bowl.
5
A
G
B
F
C
E
5A
7A
7B
7C
5B
6A
6A
6B
6C
D
To Next Page
Loading...