Step 1
Mix up a quantity of rapid epoxy and
apply to the wing root ensuring that it is
thoroughly coated.
Step 2
Push the wing panel firmly against the
mating surfaces of the fuselage ensuring
that it is correctly aligned.
Step 3
Apply strips of tape to hold the wing in
place as the epoxy cures. Wipe off any
excess adhesive before it sets.
Step 4
Repeat the process for the second wing
panel, again using sufficient rapid epoxy.
Step 5
Apply strips of tape to hold the wing in
place as the epoxy cures.
ASSEMBLING THE SQUALL EDF
To Next Page
Loading...