Step 6
Prepare your elevon servos by connecting
a pair of 300mm extension leads.
Step 7
Test fit the servo in its moulded cut-out,
then apply a smear of epoxy to the servo.
Step 8
Push the servo into position ensuring that
the lead exits in its moulded slot and the
output horn is to the rear.
Step 9
Ensure that there is no excess lead trapped
under the servo through the surface of the
wing by gently pulling the lead taut.
Step 10
Glue the second servo in position, again
ensuring the lead is pulled down into its
moulded slot.
To Next Page
Loading...