Why is CO gas consumption too high in my Phcbi MCO-5AC?
Excessive CO gas consumption in your Phcbi Farm Equipment could be due to: * Frequent opening of the outer and inner doors. * Gas leakage at the connection or pinhole on the gas tube. * An incomplete seal of the inner door gasket. * The access port at the upper left corner being open.
How to troubleshoot a Phcbi MCO-5AC Farm Equipment that does not operate at all?
If your Phcbi Farm Equipment isn't operating, check the following: * Ensure the unit is correctly plugged into a power outlet. * Verify that the circuit breaker at the power source is active and that there isn't a power failure. * Confirm that the power supply removable cord is connected to the port on the rear of the cabinet.
What to do if CO gas density doesn't coincide with the set value in Phcbi Farm Equipment?
If the CO gas density in your Phcbi Farm Equipment doesn't match the set value: * Ensure the secondary pressure is set to 0.03 MPa(G) (0.3 kgf/cm2(G), 4.4 psi(G)). * Check if the gas tube is clogged or chinked. * Verify the humidifying pan is filled with sterile distilled water.
What to do if the chamber temperature is not equal to the set temperature in Phcbi MCO-5AC?
If the chamber temperature in your Phcbi Farm Equipment isn't reaching the set temperature: * Ensure the ambient temperature is at least 5 °C less than the set temperature. * Make sure the outer door is closed while the inner door is also closed.
Why does it take so long to recover the CO gas density in my Phcbi Farm Equipment?
If recovery of CO gas density in your Phcbi Farm Equipment is slow: * A HEPA filter is provided in the CO gas piping. * If CO gas pressure is normal, dust on the HEPA filter might be obstructing the CO gas flow.
What to do if the chamber humidity does not rise in Phcbi Farm Equipment?
If the chamber humidity in your Phcbi Farm Equipment isn't rising, ensure the humidifying pan is filled with sterile distilled water.
Why is the key operation disabled on my Phcbi Farm Equipment?
If the key operation is disabled on your Phcbi Farm Equipment, the key lock function is likely set to the ON mode.
Explains warning/caution signs and key safety alerts regarding CO2 gas.
Covers safe installation practices, grounding, and electrical connections.
Details safe handling, power cord usage, unplugging, and storage guidelines.
Outlines safety for operation, environment, and use of dedicated circuits.
Describes how the incubator resumes operation after a power interruption.
Essential safety guidelines for operating the UV lamp to prevent harm.
Procedure to adjust the duration the UV lamp remains active after door closure.
Instructions for activating the UV lamp for continuous 24-hour sterilization.
General| Brand | Phcbi |
|---|---|
| Model | MCO-5AC |
| Category | Farm Equipment |
| Language | English |
To Next Page
