4. Wait for a second till the following page appears. If the IP Address displays as 0.0.0.0, you are
failed to connect to the network, please try again. If not, the wireless network connection is
successful.
The PHICOMM Wireless Utility icon on the taskbar will display as . Green bars
show the quality of wireless signal, means no signal while means full signal.
Enable WPS Function
You can apply WPS in three ways:
WPS Button (Recommended) - The device to which you are connecting must have a WPS
button available on its panel.
PBC - The device to which you are connecting must have a WPS button available on its panel
or as part of its software interface.
PIN Code - Use this method if the device to which you are connecting has no WPS button.
To Next Page
Loading...
General