Philco KG7 - Frigidaire FG7 Series Gas Furnace Features; Diagnostic Lights for Troubleshooting

Davies Supply Group Ltd.
Calgary (800) 661-1346 Lethbridge (877) 595-7707 Saskatoon (877) 355-3377
(403) 244-2161 (403) 381-7707 (306) 933-2433
Furnaces
A41
22/02/13
Frigidaire FG7 Series Gas Furnace Features & Benefits
 Category IV Venting System: May be vertically or horizontally vented using either a non-direct vent (1 pipe) or
direct vent (2 pipe) system
 100% fired and tested: All units and each component are tested on the manufacturing line
 Low boy height: Easy to apply in low ceiling applications, work well with taller high SEER coils
 Best packaging in the industry: Unique corner post design assure product will arrive to the homeowner dent free
 Tubular primary heat exchanger: Heavy gauge aluminized steel heat exchanger and stainless steel secondary
heat exchanger assure a long life
 30 second blower delay at start-up: Assures a warm duct temperature at furnace start-up. Adjustable blower
settings (60, 90, 120 and 180 seconds)
 30 second post purge: Increases life of heat exchanger
 Hot surface igniter: Innovative application of a silicon nitride igniter. Utilizes proven Smartlite® technology
 Color coded wire harness: Designed to fit the components, all with quick connect fittings for ease of service
 High static blowers: All models equipped with high static blowers
 90 second fixed cooling cycle blower off delay (TDR): Increases cooling performance when matched with a coil
 LP convertible: Simple burner orifice and regulator spring change for easy of convertibility
 Diagnostic lights for easy troubleshooting without counting flashes: Dedicated light for flame signal strength
and 2 lights in combination to indicate all other fault codes
 Integrated control board: Incorporates connections for electronic air clear and humidifier
 Two piece door design: Enhances furnace appearance and uses captured screw to prevent loosing door screws
 Blower compartment: Sealed door to reduce air leakage and insulated for ultra quiet operation
 Sealed vestibule: Reduces burner and inducer sound levels
 Rounded corner jacket: Provides an "appliance appearance"
 CSA certified design
 115V, 60Hz. Gas connections are 1/2" NPT
WARRANTY ON FRIGIDAIRE FURNACES
Warranty Details:
Lifetime Heat Exchanger and 10 years on all parts when product is
registered, 20 years Heat Exchanger and 5 year parts when not registered
10 Year Comfort Quality Pledge:
Replacement of the entire unit if Heat Exchanger fails within the first 10
years when registered, 1 year when not registered
Warranty Registration:
Register your system within 60 days of installation
Extended Warranty Protection:
Ask your Davies Rep for specific details on labor protection plans
C & L are Energy Star rated