Philco PLCE06GGPWT - Excessive Foam or Unsatisfactory Washing Result

70
CHAPTER -9: TROUBLESHOOTING
Excessivefoamis
formedinthedetergent
drawer.
Excessiveamount
ofdetergentused.
PressonStart/Pause
buttonToeliminatefoam
formation,mixaspoon
ofsoftenerwithhalf
litresofwater,andpour
themixtureinthedeter-
gentdrawer.After5-10
minutes,pressonStart/
Pausebuttonagain.In
yournextwashingopera-
tion,Adjustthedetergent
doseaccordingly.
Usedetergents
producedonlyfor
automaticwashing
machinesinyour
machine.
Wrongdeter-
gentused.
Thecontaminationde-
greeofyourlaundries
doesnotmatchthe
programmeyouhave
chosen.
Selecttheprogramme
appropriateforthe
contaminationdegree
ofyourlaundries.(See
programmetable)
Adjusttheamountof
detergentbasedonthe
amountandcontami-
nationdegreeofyour
laundries.
Amountofdetergent
usedinsufcient.
Laundriesinex-
cessofmaximum
capacityputinyour
machine.
Loadyourmachinewith
laundries,amountof
whichwillnotexceed
maximumlaundryca-
pacity.
Unsatisfactory
washingresult.
FAULT
POSSIBLE
CAUSE
TROUBLE-
SHOOTING