magic voice effect. To exit the magic voice effect mode press the button (6) twice.
Short press /LED button (6) to switch ear LEDs (3) On/Off.
Backing track playback from Bluetooth or micro SD card
Once you have a successful Bluetooth connection you can select and start playback of backing tracks stored on the Bluetooth device using the device’s controls.
Alternatively you can play MP3 backing tracks loaded on to a micro SD card, insert the card into the micro SD card slot (13) and you will hear the message “SD
card mode” and the tracks will start playing automatically.
Once you have started playing a backing track use the /V- Previous/ Pause/V+ Next buttons (7, 8, 9) to select and play the tracks you want in both micro
SD card mode and Bluetooth mode.
When an micro SD card is loaded the mic switches to micro SD card mode automatically, press the /M Pause button (8) twice to switch to Bluetooth mode,
press twice again to switch back to micro SD card.
Backing track volume
Press and hold down the speaker /V-button (7) to reduce the volume of the backing track, press and hold down the speaker button (9) to increase the
volume of the backing track.
Voice volume
Sing/speak into the top of the microphone grille adjusting the mic to mouth distance and the Mic Input Vol +/- (5) slider switch to get the correct volume.
Echo/reverb effect
Use the Echo/Reverb +/- Slider Switch (4) to add/adjust echo/reverb effect.
Line out socket
The 3.5mm line out socket can be used for playback to headphones, speakers, amplifiers or other audio output equipment.
Troubleshooting
If you are experiencing problems with your wireless karaoke mic there are some quick and easy checks below, which may help to solve the problem.
Problem Solutions
There is no power
1.Ensure the mic is switched on correctly
2.Make sure your mic is charged
There is no backing sound output
1.Adjust the Speaker Vol + and VOL- (7,9) on the mic
2.Make sure the Bluetooth device is playing and adjust the volume
3.Make sure that your Bluetooth device is in effective range
4.Ensure that the Bluetooth device is paired
5.Make sure you have selected the correct audio source
6.The track format may be incompatible ensure all music files are MP3 format
There is no voice output 1. Adjust the Mic VOL+/- Slider Switch (5)
There is a ringing/ squealing noise
(feedback)
1.Reduce the echo/reverb using the Echo/Reverb 4+ Slider Switch (4)
2.Reduce the /V- (7) and Mic VOL+/- (5)
Specifications
Source Input:
Bluetooth device or
TF / Micro SD card (maximum size 32GB)
Input: 5V= 500mA
Speaker output: 5W
Frequency range: 100Hz-10KHz
Bluetooth version: V5
Transmission distance: 10m approx.
Battery capacity: 1200mAh/3.7V
Charging time: 3 hours approx.
Dimensions: 98 x 66 x 233mm
Disclaimer
Updates to Firmware and/or hardware components are made regularly. Therefore some of the instructions, specifications and pictures in this documentation may
differ slightly from your particular situation. All items described in this guide are for illustration purposes only and may not apply to your particular situation. No
legal right or entitlements may be obtained from the description made in this manual.
Declaration of Conformity
Hereby, Philex Electronic Ltd. declares that the radio equipment model 90043PI Wireless Karaoke Mic for radio broadcast reception in domestic premises is in
compliance with the Radio Equipment Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
www.philex.com/doc
To Next Page
Loading...