Philips Ledalite Airwave

To Next Page

To Previous Page

Product Manual

17.0 Clearing Devices from a Transceiver

TherearetwodifferentmethodstoclearaSwitchand/orPhotosensorfromaTransceiver.OneistousethepushbuttonsontheTransceiverandthesecondistoclearusingthewirelessSwitch.

17.1 Clearing using Push Buttons on the Airwave Transceiver

Step 1: Apply power to Transceiver.

Step 2: PressandholdtheClearbuttonuntiltheLinkLEDturnsON(approximately3seconds).ThePowerLEDwillblinksteadily.

NOTE:Thismethodwillclearalldevicesatonce.

17.2 Clearing using an Airwave Wireless Switch only

See Section 19 for entering conﬁguration mode and Section 20.7 for instructions on clearing a Switch.

18.0 Understanding LED Blink Patterns

Afterlinkingiscomplete,thePowerLEDwillblinkinapatterndependingonwhattypesofdevicesarelinkedtotheTransceiver:

Power LED Action/Device Linked

#ofBlinks

Devicelinked

WirelessSwitch(oneormore)

Occupancysensor(wiredorwireless)

WirelessPhotosensor(one)

Demand Response Transmitter

Philips Ledalite Airwave - Page 16