Philips 107E7 - Page 74

17” CDT Color Monitor 107E7
74
5.15.1 Transportation packages
Packaging and wrapping shall be sufficient to protect the product against damage or loss
during shipment from the supplier to the destination specified in the purchase order. All
packaging materials are subject to test and evaluation per TYE-M0002. The cushion material
shall be constructed using EPS material.
Carton paper (Double wall AB flute corrugate board, colour brown)
Bursting - 19.3 kgf/cm
2
min
Compression - 670 kgf min
5.15.2 Transportation test procedures
The overall test sequence is: vibration test, drop test and when applicable cold drop test. The sequential tests
have to be carried out using the same packaging.
Vibration, drop test should be performed at ambient temperature (20°C to 23
o
C) and relative
humidity (40% to 65%).
---DBC test required and refer to TYE-M0002.
•
Transportation test specification for all regions except China/India, refer to UAN-D1534/01
Sequential tests:
1. Vibration test
2. Drop test
3. Single package resonance test (optional)
4. Compression test
5. Stacking test (optional)
•
Transportation test specification for China/India, refer to UAN-D1534/02
Sequential tests:
1. Vibration test
2. Bump test
3. Drop test
4. Multiple drop tests (after vibration)
5. Cold drop test when applicable (after vibration)
6. Compression test
7. Stacking test (optional)
5.16 Pallet / Container loading
• Air shipment - tbc
•
Sea container 20'(pallet/slip sheet) - 300 sets with pallet
310 sets without pallet