Philips 150P - Optical Characteristics

• Video dot rate 80 MHz
• Input impedance
- Video 75 ohm
- Sync 2 kOhm
• Input signal levels 700m Vpp
• Sync input signal
Separate sync
Composite sync
• Sync polarities Positive and negative
• Input Frequency
XGA Hsync 48- 60 KHz, Vsync 60 - 75 Hz (N.I.)
SVGA Hsync 35- 50 KHz, Vsync 56 - 75 Hz (N.I.)
VGA Hsync 31- 38 KHz, Vsync 60 - 75 Hz (N.I.)
• Video interface
Dual input: Both Analog (D-Sub) and DVI-D (Digital only) are
available It can be switching via OSD selection.
AUDIO
• Input signal levels 0.4Vpp
• Headphone out signal level 32 ohm 50 + 50 mW
• Input signal connector 3.5mm mini jack
• Loudspeakers 1 + 1 W stereo front firing
MICROPHONE
• Sensitivity -51dB to -41dB
• Output impedance 600Ohm typical
• Directivity -15dB at 180+ 20°
• Frequency range 500Hz~2KHz
OPTICAL CHARACTERISTICS
• Contrast ratio 250 (typ.)
• Brightness 210 nits (typ.)
• Peak contrast angle 6 o'clock
• White Chromacity x: 0.281 y: 0.311 (at 9300° K) x: 0.312 y: 0.338 (at 6500° K)
• Viewing Angle (C/R >5)
Upper >55 ° (typ.)
Lower >55° (typ.)
Left >75 ° (typ.)
Right >75 ° (typ.)
150P Product Information
file:///E|/manual/english/150P/product/product.htm (2 of 5) [12/13/1999 8:00:40 PM]