directions. (Note: INPUT SELECTION is not available on all monitors. If not on your
monitor, RESET TO FACTORY SETTINGS is your last selection.)
… to exit completely, press the button.
RETURN TO TOP OF THE PAGE
INPUT SELECTION (not available on all monitors)
INPUT SELECTION allows you to decide whether the video input into your monitor comes from a digital or
analog source. This is determined by how the video signal is sent from your computer to your monitor.
To find out if the signal is digital or analog, first consult the owner's manual for your computer. Second,
make sure you have the correct connection made to your monitor. If your computer supports both analog
and digital output or if you have two computers connectors to your monitor (one with analog output and one
with digital output), you can also use this setting to switch between the two video signals as desired.
1) Press the OK button on the monitor. The MAIN CONTROLS window appears. LANGUAGE is highlighted.
2) Press the
button until INPUT SELECTION is highlighted.
3) Press the button. The INPUT SELECTION window appears.
4) Press the
or button to select either ANALOG or DIGITAL.
file:///E|/manual/english/150P/osd/osd_cont.htm (18 of 20) [12/13/1999 8:01:22 PM]
To Next Page
Loading...
