4. Fix the USB Hub to the monitor by screwing
5. Do not tighten the fixing nut excessively (use fingers to tighten screws). If screwed too tight, the unit may
not connect properly!
6. Plug-in the power cord and turn on the monitor.
7. The two ends of USB cable attached are different.
Plug in the square end into the "upstream" connector of
the USB Hub.
8. Plug-in the other end into the USB connector of the PC.
RETURN TO TOP OF THE PAGE
file:///E|/manual/english/150P/install/usbhub/usb_inst.htm (4 of 4) [12/13/1999 8:01:05 PM]
To Next Page
Loading...
