Micromario
non-DI RU_EN
90x127mm
When display shows F0
When display shows A3 / C7 / F1
The lter may produce smell after being used
for a while because of the absorption of indoor
air. Remove the lter and place it where it has
direct sunlight and ventilation for several hours.
Re-install and try using it again. If the odor
remains, please replace the lter.
Maintenance
Clean the pre-lter and wick
Time to replace NanoProtect lter
Time to replace wick
Descale the wick with the water and white
vinegar or citric acid, rinse with water and air dry.
EVERY
WEEK
Time to replace Active Carbon lter
!
Press for 3 seconds to reset after
cleaning or replacing accessory
Rinse the water tank, the water tray and the
NanoCloud rotray humidication wick.
4241 211 00181-1
Allergen
mode
2-in-1
mode
Auto
mode
Purication
ONLY mode
Sleep
mode
Filter
replace
alert
Water
rell
alert
Pre-lter
cleaning
alert
Child
lock
Auto
Mode
Fan
speed
Power
Hold for 3 seconds
Hold for 3 seconds: Display switch between
PM2.5 / IAI / Current humidity level
Humidity
setting
Light
dim
Timer/
Reset
2-in-1
mode
on/o
NanoCloud technology evenly distributes invisible water vapour into your room.
In dry conditions moisture from the humidier will be absorbed by walls,
furniture, and other items in your room. Ventilation of dry outside air will also
increase the time it takes to reach the target humidity.
To optimize humidication and purication performance, it's recommended to
close doors and windows during use.
Control
Display
Good Poor Very poorFair
Allergen index from 1 to 12
where 1 indicates best air quality
3-digit display PM2.5 /
IAI / Humidity level
PM2.5
indicator
Indoor Allergen
Index
Air quality
ring
2 hours
NanoProtect lter Series 3
NanoProtect lter
Active Carbon
Pre-lter
Wick
To Next Page
Need help?
General
