!
80
Meridian 3
6 MECHANICAL CHARACTERISTICS
6.1 Cosmetic -
Philips ID
6.2 Mechanical data files -
ProE files required
6.3 Location of Philips logo -
Per Philips make-up sheet
6.4 Gap between panel and front bezel
< 1.2mm (Typ.)
6.5 Location of Control icons -
Per Philips Graphic sheet
6.6 Color for resin/paint -
Per Philips make-up sheet
6.7 Fire enclosure request
Shielding Cover should fulfill international standard
6.8 Resins
x RoHS required
x WEEE required.
x Resin type/selection refer to Project Book Section 7.2 Plastic material.
6.9 If paint is used
x RoHS required
x WEEE require
x If new painting type need to implement, refer to UN-D 1235.
6.10 Plastic mold tooling
x Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld
lines, gate marks, ejector marks, etc.). Refer to “TYV61-90007”.
x Painting to cover up cosmetic defects due to molding is strongly discouraged.
x China RoHS mark requested.
6.11 Plastics flammability
x
All Plastics to be Flame Retardant UL 94-HB or Better.
x Base / Pedestal to be Flame Retardant UL 94-HB.
x All major plastic parts (bezel, back cover) need to be molded from same resin.
x Plastic resin type selection should be referred to “plastic-Philips Pool monitor”.
6.12 Texture/Glossing of housing
x The texture area and texture no should follow Philips make-up sheet.
x The exterior surfaces shall have a uniform texture.
x Philips must approve the mold texturing.
x Detail document for texture refer to “UN-D249”, “UN-D 600”.
x < = 20 gloss units
To Next Page
Loading...
