ˉˇʳʳʳ˅ˇ˃ˣ˪ˌʳʳ˟˖˗ʳ
General Product Specification
3.3 OSD behavior
Please refer to following Hudson9 OSD definitions, if any deviation, then refer to PVT Exit
sample.
ITEM
1 OSD DEFINITIONS
˛˷ʳˋʳˢ˦˗ʳ
˗˸˹˼˼˼ʳˀʳ˄ˇˁ˷˶
Reset -
No: Exit
Yes: Auto adjustment for
displaying timing mode and
recall factory preset
2 OSD LANGUAGES
˛ˌʳˢ˦˗ʳ˴˿˴˼ʳˀʳ
˅˃˃ˋ˃ˈ˄ˉʳˀʳ˙˼˴˿ˁ˿
LANGUAGES
3 OSD TREE
˕ʳ˷˸˹˼˼˼ʳ˲ʳ
˅˃˃ˋ˃ˉ˄ˌˁ˿
4 POWER ON LOGO
˅ˇ˪˲˄ˌ˅˃˄˅˃˃˲˸
ˁ˼
Power On Logo: Power On
Show up Philips logo 3
seconds
Change to input signal.
This picture is reference
only. The official drawing
will send out by PM.
5
Audio Selection Stand-alone – On:
Isolate video and audio
control input
Stand-alone – Off:
Integrate video and
audio control input
Mute – On: Turn off audio
Mute – Off: Turn on audio
3.4 Horizontal scanning
Sync polarity : Positive or Negative
Scanning frequency : 24 – 94 K Hz
ˆˁˈ
ˆˁˈˆˁˈ
ˆˁˈ ˩˸˼˶˴˿ʳ˶˴˼˺
˩˸˼˶˴˿ʳ˶˴˼˺˩˸˼˶˴˿ʳ˶˴˼˺
˩˸˼˶˴˿ʳ˶˴˼˺ʳ
ʳʳ
ʳ
ʳ
Sync polarity : Positive or Negative
Scanning frequency : 48 - 85Hz
To Next Page
