10
2. Setting up the monitor
2.3 Remove the Base Assemb ly
for V ESA Mounting
Before you start d isassemb ling the
monitor b ase, p lease follow the
instructions b elow to avoid any p ossib le
d amage or injury.
1. Extend the monitor b ase to its
maximum height.
2. Place the monitor face d own on a
smooth surface. Pay attention not
to scratch or d amage the screen.
Then lift the monitor stand .
3. While keep ing the release b utton
p ressed , tilt the b ase and slid e it
out.
Note
This monitor accep ts a
V ESA
-
omp liant mounting interface.
V ESA Mounting Screw M4. Always
contact manufacturer for wal
l-
t
installation.
100mm
100mm
To Next Page
Loading...
