!
66
Meridian 3
17. General Product Specification
FOREWORD
This specification describes a 27" FHD multi-scan color TFT LCD monitor with maximum resolution up to 1920 x
1080 /60Hz non-interlaced.
All optical characteristics (including WHITE-D, Brightness, and so on) are determined according to panel
specification after warming up approximate 30 minutes that brightness stability is optimal, and follow strictly after
panel specification.
PRODUCT PROFILE
This display monitor unit is a color display monitor enclosed in PHILIPS styling cabinet which has an integrated
tilt base.
EDID Header
Data for EDID & .inf file
1 User visible strings on .inf file
Philips 273E (27 inch WIDE LCD MONITOR
273E3)
2 Manufacturer ID ( EDID data) PHL
3 Product ID, "xxxx" 4 codes MSB(byte 12):
LSB (byte 11):
4 maximum resolution 1920x1080
5 Horizontal Frequency Range 30~83 KHz
6 Vertical Frequency Range 56~76Hz
7 Monitor Name (13 characters max.) Philips 273E
LCD (SI to feedback)
1
st
AUO 27
Type NR. : M270HW01
Resolution : 1920 x 1080 (FHD)
Outside dimensions : 630(H) x 368.2 (V) x 16.2(D) mm (Typ.)
Pitch (mm) : 0.2715mm x 0.2715mm
Color pixel arrangement : 1920 horizontal By 1080 vertical Pixels. RGB stripe arrangement
Display surface : Hard coating (3H), Anti-glare treatment of the front polarizer
Color depth : 16.7M colors
Backlight : 4 CCFL
Active area (W x H) : 597.6(H) x 336.15 (V)
View angle (CR>=10) : R/L 170(Typ.), U/D 160(Typ.)
Contrast ratio : 700:1(Min),1000:1 (Typ)
White luminance : 400 cd/m2(Typ. Center 1 point)
Color gamut : >=72%
Gate IC : N/A
Source IC :
Response time : <=5 ms (Typ)
Scanning frequencies
Hor. : 30 – 83 K Hz
Ver.: 56 - 76 Hz
Video dot rate: 1. RGB support up to165 MHz
(warning message must be displayed while over 165 MHz)
Power input: 90-264 V AC, 50/60 r 2 Hz
Power consumption: (without audio)
47 W typ.
< 55 W max.
To Next Page
Loading...
