Alignments
EN 19TPM4.1E LA 6.
2011-Jan-21
6.5.2 V-com adjustment
Press Remote control “147852+info” Key, or press
“062596+Info” for TV V-com adjustment, enter the V-com
adjustment mode with a pattern (Green 2) as
shown in Figure 6-2
.
Figure 6-2 1920 × 1080 @ 60 Hz, Pixel ON/OFF pattern
Press up/down key of remote control to select V-com in the
OSD. Press the right/left buttons on the remote control to
fine-tune V-com untill minimum or no flicker is detected.
Press the “Store” key to save the aligned VCOM data into NVM.
Note: Make sure you get the optimum result before saving.
This data is saved in the NVM of the IC MAX9668ETP (U7401).
This device can only be rewritten 100 times!
6.6 Option Settings
6.6.1 Reset Options
In SAM, after reset “Reset option code”, restart the set
immediately.
6.6.2 Option Code Overview
Table 6-3 Option code overview
6.7 Serial Number Definition
Table 6-4 BOM Code
CTN_ALT BOM# Panel Type Panel ID
32PFL3205/12_1 LG LC320WUY-SCB1 117
32PFL3605/12_1 LG LC320WUY-SCB1 117
42PFL3605/12_1 LG LC420WUY-SCB1 116
32PFL3605/60_1 LG LC320WUY-SCB1 117
42PFL3605/60_1 LG LC420WUY-SCB1 116
Panel Supplier Code
AU 1
CPT 2
LPL (LG) 3
QDI 4
CMO 5
HSD 6
SVA 7
18850_207_100107.eps
100107
R
Row 1
Row 2
Row 3
Row 4
127 gray
0 gray
G B R G B R G B R G B R G B
To Next Page
Loading...
