Philips 34E1C5600HE - Multiview Faqs

33
Q13: How to unlock/lock my hot key?
Ans.: Please press for 10 seconds
to unlock/lock the hot key, by
doing so, your display pops out
“Attention” to show the unlock/
lock status as shown below
illustrators.
  
  
Q14: Where can I nd Important
information manual mentioned
in EDFU?
Ans.: Important information manual
can be download on the Philips
website support page.
9.3 Multiview FAQs
Q1: Can I enlarge the PIP sub
window?
Ans.: Yes,thereare3sizestoselect:
[Small],[Middle],[Large].You
canpress to enter OSD menu.
Select your preferred [PIP Size]
option from the [PIP / PBP] main
menu.
Q2: How to listen to Audio,
independent of video?
Ans.: Normallytheaudiosourceis
linkedtothemainpicturesource.
If you want to change audio-
sourceinput,youcanpress
to enter OSD menu. Select your
preferred [Audio Source] option
from the [Audio] main menu.
Pleasenotethatthenexttime
youturnonyourdisplay,the
displaywillbydefaultselectthe
audiosourceyouchoselasttime.
Incaseyouwanttochangeit
again,youneedtogothrough
theabovestepstoselectyour
newpreferredaudiosource,
which then will become the
“default” mode.
Q3: Whythesub-windowsickers
when I enable PIP/PBP.
Ans: It’sbecausethesub-windows
videosourceisinterlacetiming
(i-timing),pleasechangesub-
windowsignalsourcetobe
progressivetiming(3P-timing).