Do you have a question about the Philips 39PFL3188H/12 and is the answer not in the manual?
Provides product information, user manuals, FAQs, and software/drivers.
Guidelines for safe electrical repairs and component replacement.
Alerts regarding electrostatic discharge and high voltage sections.
Step-by-step instructions for rear cover and speaker removal.
Instructions for rear cover removal and component access.
Procedures for rear cover and small signal board removal.
Guidance on using test patterns and ComPair for fault diagnosis.
Details Service Default Mode (SDM), SAM, Factory, CSM, and ComPair.
Introduction and connection guide for the ComPair service tool.
Steps for updating TV software via USB.
Method for identifying errors using front LED pulses.
Troubleshooting advice for NVM Editor, HDMI, and audio amplifier.
Procedure for adjusting White Tone using SAM mode.
Procedure for resetting NVM and reloading MAC address.
Description of the power architecture and control signals.
Circuit diagram for the A 715G6163 PSU, AC input section.
Circuit diagram for the A 715G6297 PSU, POWER section.
Schematics for the BA 715G6079 SSB+PSU combination panel.
Schematics for the B 715G6092 SSB, Power-1 section.
Schematics for the B 715G6094 SSB, Power-1 section.
Provides product information, user manuals, FAQs, and software/drivers.
Guidelines for safe electrical repairs and component replacement.
Alerts regarding electrostatic discharge and high voltage sections.
Step-by-step instructions for rear cover and speaker removal.
Instructions for rear cover removal and component access.
Procedures for rear cover and small signal board removal.
Guidance on using test patterns and ComPair for fault diagnosis.
Details Service Default Mode (SDM), SAM, Factory, CSM, and ComPair.
Introduction and connection guide for the ComPair service tool.
Steps for updating TV software via USB.
Method for identifying errors using front LED pulses.
Troubleshooting advice for NVM Editor, HDMI, and audio amplifier.
Procedure for adjusting White Tone using SAM mode.
Procedure for resetting NVM and reloading MAC address.
Description of the power architecture and control signals.
Circuit diagram for the A 715G6163 PSU, AC input section.
Circuit diagram for the A 715G6297 PSU, POWER section.
Schematics for the BA 715G6079 SSB+PSU combination panel.
Schematics for the B 715G6092 SSB, Power-1 section.
Schematics for the B 715G6094 SSB, Power-1 section.












Loading...