Source
This menu allows you to identify the accessory devices you have connected to the external
inputs/outputs.
& Select Source in the Setup menu.
é Press the cursor right.
“ Select the input to which the accessory device
is connected.
‘ Press the cursor right again to enter the list of
types of devices connected to the selected
input.
( Select the accessory device with the cursor
up/down.
When you select AV1, AV2, AV3, HDMI1, HDMI2, Side or Digital Audio In,a list appears allowing
you to identify which type of accessory device is attached to this input.The TV detects the presence
of the connected device and the signal is routed appropriately.
Once you have selected the source type, e.g. DVD, this source will automatically be selected when
your remote control is in DVD mode, see p. 8, and when you press the
AV+ button on the remote
control.
Digital Audio
Select
Digital Audio In when the TV expects digital audio for a connected device to come from a
Digital audio input.
Make your selection of the source to which the device with digital audio input has been connected.
In addition to accepting audio input via Digital Audio In, the TV can output Digital audio via the
DIGITAL AUDIO OUT connector to an external amplifier or receiver.
If your amplifier or receiver has a matching connector for Digital Audio In, you can connect it with a
single cable to the TV’s
DIGITAL AUDIO OUT.
See Connect Accessory Devices, Digital Surround Receiver, p. 59.
Settings
Setup
Preferences
Source
Clock
Source
AV1
AV2
AV3
HDMI
.......
Info
23
English
To Next Page
Loading...
