17
Advanced
Language
English
中文（中国）
HDMI Version
HDMI1.4
Available only 43X8050
HDMI2.0
Power On Mode
Power On
Standby
Last Status
Boot On Source
Switch On/O
Boot On Source
HDMI1/ HDMI2/ PDF/ Media/
Cloud CMS/ Customer/ Last
Source/ VGA/ USB
1. When SCHEDULE is set with
startup time, but the startup time
has not arrived yet, boot the device
according to the signal source set in
the “Boot On Source”.
2. If the source is set in USB,
the booting page is the “U disc
homepage”.
Play List Play list [1 … 7]
1.Play List is grayed
2.When the Boot On Source is
PDF or Media Player, Play List is
available.
Boot Wake
UART Wake On/O
When UART wake = On
，
RC o or
power saving can both be waken up
by UART wake.
HDMI/VGA Wake On/O
When HDMI Wake = On, and the
current source is HDMI1/2, power
saving and the current HDMI source
are waken up with signals.
RS322 Control On/O
Pixel Shift On/O
Uplayer Setting
Switch On/O
1.When Uplayer Setting switch
on, Boot On Source is grayed, the
setting is unavailable.
2.Supported le name
：
SuperU
3. To play content in UPlayer, the
system will cut the signal source
to USB, and stay at the USB source
when plugging and unplugging the
USB ash drive.
4. Pivot jump to U_Player when
booting, the priority is higher than
the source specied by the schedule
boot
Repeat Time 8S/16S/24S/32S
Supported le type
：
1
、
Photo: ".png", ".jpg"
2
、
Video: ".dat", ".vob", ".ts", ".mkv",
".mov", ".3gp", ".v", ".webm",
".wmv", ".asf", ".mp4", ".avi", ".mpg".
Restore Restore Default Cancel/OK System Reset
Notes: To wake up PD in the HDMI source, you can set HDMI wakeup “On”.
This product supports timed shutdown and timed startup functions. Refer to the “Shutdown time/Startup time” in the upper
table for details.
To Next Page
Loading...
